Job Spool setting
msh> spoolsw spool {on|off}
• Specify "on" to enable Job Spool, or "off" to disable it.
Resetting Job spool setting
msh> spoolsw clear job {on|off}
• When the printer power is cut during job spooling, this determines whether to reprint the spooled
job.
Protocol configuration
msh> spoolsw diprint {on|off}
msh> spoolsw lpr {on|off}
msh> spoolsw ipp {on|off}
msh> spoolsw smb {on|off}
msh> spoolsw ftp {on|off}
msh> spoolsw sftp {on|off}
msh> spoolsw wsprn {on|off}
ssdp
Use the "ssdp" command to view and configure SSDP settings.
View settings
msh> ssdp
Setting effective time
msh> ssdp profile [1801-86400]
The default is 10800 seconds.
Advertise packet TTL settings
msh> ssdp ttl [1-255]
The default is 4.
ssh
Use the "ssh" command to view and configure SSH settings.
View settings
msh> ssh
5. Monitoring and Configuring the Printer
204
To Next Page
Loading...
