Toshiba GX9 User Manual

94 GX9 ASD Installation and Operation Manual
Output Terminal 4 (OUT3) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the OUT3 discrete output
terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable OUT3 terminal to one of
the user-selectable functions listed in Table 10 on pg. 222.
Note: The Expansion IO Card Option 1 option board (P/N ETB003Z)
is required to use this terminal.
See the Expansion IO Card Option 1 instruction manual (D/N 58685) for
more information on the function of this terminal.
Direct Access Number — F133
Parameter Type — Selection List
Factory Default — Lower Limit
Frequency
Changeable During Run — No
Output Terminal 5 (OUT4) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the OUT4 discrete output
terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable OUT4 terminal to one of
the user-selectable functions listed in Table 10 on pg. 222.
Note: The Expansion IO Card Option 1 option board (P/N ETB003Z)
is required to use this terminal.
See the Expansion IO Card Option 1 instruction manual (D/N 58685) for
more information on the function of this terminal.
Direct Access Number — F134
Parameter Type — Selection List
Factory Default — Upper Limit
Frequency
Changeable During Run — No
Output Terminal 6 (R1) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the R1 discrete output
terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable R1 terminal to one of the
user-selectable functions listed in Table 10 on pg. 222.
Note: The Expansion IO Card Option 1 option board (P/N ETB003Z)
is required to use this terminal.
See the Expansion IO Card Option 1 instruction manual (D/N 58685) for
more information on the function of this terminal.
Direct Access Number — F135
Parameter Type — Selection List
Factory Default — Speed Reach Signal
Changeable During Run — No
F133 F135

Toshiba GX9 Specifications

General

Brand	Toshiba
Model	GX9
Category	Controller
Language	English