Toshiba GX9 - Page 218

206 GX9 ASD Installation and Operation Manual
Disconnection Detection Extended Time
Program Communications S20 Settings
This parameter is used to set the length of time that no communications activity
may exist before the communications link is disconnected.
Settings:
0 — Mode 0
1 — Mode 1
2 — Mode 2
3 — Mode 3
4 — Mode 4
Direct Access Number — F850
Parameter Type — Selection List
Factory Default — Mode 0
Changeable During Run — Yes
ASD Operation at Disconnection
Program Communications S20 Settings
Not Used.
Direct Access Number — F851
Parameter Type — Numerical
Factory Default — 200
Changeable During Run — Yes
Minimum — 0
Maximum — 1000
Units — Seconds
Receive Address
Program Communications S20 Settings
Not Used.
Direct Access Number — F860
Parameter Type — Numerical
Factory Default — 0
Changeable During Run — Yes
Minimum — 0
Maximum — 1023
Transmit Address
Program Communications S20 Settings
Not Used.
Direct Access Number — F861
Parameter Type — Numerical
Factory Default — 0
Changeable During Run — Yes
Minimum — 0
Maximum — 1023
Speed Reference Station
Program Communications S20 Settings
Not Used.
Direct Access Number — F862
Parameter Type — Numerical
Factory Default — 0
Changeable During Run — Yes
Minimum — 0
Maximum — 64
Speed Reference Address
Program Communications S20 Settings
Not Used.
Direct Access Number — F863
Parameter Type — Numerical
Factory Default — 0
Changeable During Run — Yes
Minimum — 0
Maximum — 1023
F850 F863