What causes ASD Overload on my Toshiba GX9?
If your Toshiba Controller displays an ASD Overload error, it may be caused by: * The carrier frequency being too high. * An excessive load. * Acceleration time being too short. * DC damping rate set too high. * The motor starting into a spinning load after a momentary power failure. * The ASD being improperly matched to the application.
Why does my Toshiba Controller show an Over-Voltage error?
If the Toshiba Controller displays an Over-Voltage error, it could be due to: * The ASD attempting to start into a spinning motor after a momentary power loss. * Incoming commercial power exceeding the specified range. * Decel time being too short. * Voltage spikes at the 3-phase input. * A DBR requirement or the DBR resistance value being too high. * The DBR function or Over-Voltage Stall feature being turned off. * System regeneration or load instability. * The Ridethrough function being enabled.
General| Brand | Toshiba |
|---|---|
| Model | GX9 |
| Category | Controller |
| Language | English |
To Next Page