Toshiba HX7+ ASD - Direct Access Parameter Information; Accessing Parameters via Direct Access Numbers; Automatic Accel;Decel #1; Command Mode Selection

HX7+ ASD Installation and Operation Manual 63
F REQUENCY S ETTING
Preset Speeds
#5 Frequency & Characteristics F022
#6 Frequency & Characteristics F023
#7 Frequency & Characteristics F024
#8 Frequency & Characteristics F287
#9 Frequency & Characteristics F288
#10 Frequency & Characteristics F289
#11 Frequency & Characteristics F290
#12 Frequency & Characteristics F291
#13 Frequency & Characteristics F292
#14 Frequency & Characteristics F293
#15 Frequency & Characteristics F294
Preset Speed Mode
Use Preset Speed (check box) F380
Fwd/Rev Disable
Disable Forward Run/Disable Reverse Run
(check box)
F311
Motorized Pot
Motorized Pot Setting Disposition at Power
Down
F108
Minimum Frequency N/A
Maximum Frequency N/A
P ROTECTION
Dynamic Braking
Dynamic Braking Configuration F304
Stall
Over-Current Stall Level F601
Over-Voltage Stall F305
Over-Voltage Stall Level Configuration N/A
Over-Voltage Stall Level (Fast) F625
Continuing Stall Period (During Positive
Torque/Speed)
F452
Stall Prevention During Regeneration F454
Over-Heat Stall F740
DC (Injection) Braking
DC Injection Start Frequency F250
DC Injection Braking Current F251
DC Injection Braking Time F252
Motor Shaft Fixing Control (check box) F253
Motor Shaft Stationary Control (check box) F254
Emergency Off
Emergency Off Mode Configuration F603
DC Injection Braking Time F604
Emergency Off Activation of the FL Output
(check box)
N/A
Retry/Restart
Number of Retries F303
Restart Conditions (check box) F301
Scan Rate F312
Lock-on Rate F313
Program Menu Navigation
Primary Menu Sub Menu Parameter Name
Parameter
Number