Toshiba RBC-AWSU52-UL - Air to Air Heat Exchanger Functions; Setting Ventilation Fan Speed

–15–
Installation Manual
■3. Display setting
■4. Screen contrast
You can adjust the contrast of the LCD.
1 In the “Initial setting” screen, press [ ]
and [ ] to select “Display setting”, and
then press [ Set/Fix]
2 Press [ ] and [ ] to select an item
You can set the items that are black highlighted in the
display.
 Press [ ] and [ ] to switch to the setting you
want.
3 After setting each item, press [ Set/Fix]
 The changes are fixed.
Clock selection
You can set the clock display in “Clock selection”. (Factory default setting: “24h”)
 If you select “24h”, a 24-hour system is used (13:15, etc.), and if you select “AM, PM”, a 12-hour system is used
(01:15PM, etc.).
Clock display
You can delete the clock display in “Clock display”. (Factory default setting: “ON”)
 Selecting “OFF” removes the clock display from the main screen.
Power level
By selecting “OFF” in “Power level”, you can set the main screen and “Monitor” screen to not display operating power
levels, or flags when set temperatures are met. (Factory default setting: “OFF”)
Display mode
Selecting “Simple” in “Display mode” changes the main screen to the simple display. (Factory default setting: “Detailed”)
 For details about each screen, refer to <Air conditioner main screen>. (Page 12)
1 In the “Initial setting” screen, press [ ]
and [ ] to select “Screen contrast”, and
then press [ Set/Fix]
2 Press [ ] and [ ] to select the value you
want to change
3 Press [ Set/Fix]
 Return to the “Initial setting” screen.
NOTE
It is set to the central value as the factory default setting.