–22–
Installation Manual
EN
7 Field setting menu
1 Press [ Menu] to open the “Menu”
2 Press and hold [ Menu] and [ ] at the
same time to open “Field setting menu”
Press and hold 4 seconds.
3 Press [ ] and [ ] to select an item
4 Press [ Set/Fix]
The setting screen opens.
Item Description
1. Test mode Does test operations after installation. (Page 23)
2. Register service info.
Registers contact for repairs, and model names and serial numbers of indoor units
and outdoor units. (Page 25)
3. Alarm history
Displays the last 10 check codes, and when and at which unit they occurred, as
the history of check codes. (Page 29)
4. Address Check addresses and manually set addresses. (Page 30)
5. Monitor function
Monitoring data of sensor temperature, rotating speed of the compressor or other
factor. (Page 34)
6. Setting louver position
Disables operation to fix position to stop louvres when swing stops and shows
louvres’ up-down display as right-left display on the main screen. (Page 34)
7. Setting timer operation mode
Settings can be done to you can select operation mode during “Schedule timer”.
(Page 35)
8. Easy I.DN setting Sets various functions related to air conditioners. (Page 36)
9. DN setting Advanced settings using DN codes. (Page 37)
10. Reset Power Consumption data Resetting the power consumption data saved in the remote controller.
11. Notice history
Displays the last 10 notice codes, and when and at which unit they occurred, as
the history of notice codes. (Page 38)
12. Rotation backup
Sets rotation backup operations for light commercial models using group
connections. (Page 39)
13. LC Easy monitor
Check data, such as the sensor temperature on light commercial models.
(Page 40)
14. Indoor unit operation
Forces operation of drain pump, fan / louvres of indoor units to check operations.
(Page 41)
To Next Page
Loading...
