Toshiba RBC-AWSU52-UL - Connection Diagram

–8–
Installation Manual
EN
■ Connection diagram
NOTE
Wires A and B have no polarity.
CAUTION
Do not leave the excess remote controller wiring inside the remote controller case but instead bring it outside the case.
Peel off the sheath (outer skin) of wires inside the remote controller case. Excess wires may compress parts inside the
product and damage the remote controller body (including the LCD).
Proper wiring example 1
• Not coiled
• Not excessively slack
• The sheath (outer skin) of wires inside the remote
controller case is completely peeled off.
Improper wiring example 1
• Overlapped
• Excessively slack
Improper wiring example 2
• The sheath (outer skin) of wires
inside the remote controller case
is not completely peeled off.
Proper wiring example 2
• Not coiled
• Not excessively slack
• The sheath (outer skin) of wires inside the remote
controller case is completely peeled off.
Improper wiring example 3
• The sheath (outer skin) of wires inside
the remote controller case is not
completely peeled off.
Remote controller wiring (locally procured)
Remote controller
terminal board
Remote controller
* AWG20 to AWG14 (0.5 mm² to 2.0 mm²).
* Crimped terminals cannot be used.
A
A
B
B
Terminal board for indoor unit
remote controller wiring
2.36″ (60 mm) or less
1.96″ (50 mm) or
less
More than 2.36″ (60 mm)
More
than
1.96″
(50 mm)