OPERATOR’S MANUAL
series Robot Controller
Press the EXE key, and the position name is replaced by the newly specified
name. The following display appears.
P O I N T 5 5 5 5 5 [ 5 / 10]
X : 3 0 0 . 0 0 0 CONF I G : FREE
Y : 3 0 0 . 0 0 0
Z : 3 0 0 . 0 0 0
C : 3 0 0 . 0 0 0
T : 3 0 0 . 0 0 0
3 0 0 . 0 0 0 w / . w o r l d
S A V E P R G D I R T R A N S P Y L D >
• The main cursor moves to the X data area.
• If the input name is illegal, a message saying "ILLEGAL NAME" is displayed
on the command line and no data is changed.
• If the specified name already exists, a message of "DUPLICATE NAME" is
displayed on the command line and no data is changed.
STE 80720
– 5-44 –
To Next Page
Loading...
