TL-SL3428 JetStream L2 Managed Switch CLI Guide
113
Parameter
auto —— Auto negotiation (default).
10h —— 10Mbps half-duplex.
10f —— 10Mbps full-duplex.
100h —— 100Mbps half-duplex.
100f —— 100Mbps full-duplex.
1000f —— 1000Mbps full-duplex.
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Configure the Negotiation Mode as 100Mbps full-duplex for Ethernet port5:
TP-LINK(config)# interface ethernet 5
TP-LINK(config-if)# negotiation 100f
storm-control
Description
The storm-control command is used to configure the Storm Control function.
To disable the Storm Control function, please use no storm-control command.
Storm Control function allows the switch to filter broadcast, multicast and UL
frame in the network. If the transmission rate of the three kind packets exceeds
the set bandwidth, the packets will be automatically discarded to avoid network
broadcast storm.
Syntax
storm-control [bc-status bc-status] [mc-status mc-status] [ul-status
ul-status][rate rate]
no storm-control
Parameter
bc-status —— Enable/Disable broadcast control feature for the port. By default,
it is disabled.
mc-status —— Enable/Disable multicast control feature for the port. By default,
it is disabled.
ul-status —— Enable/Disable UL-Frame control feature for the port. By default,
it is disabled.
rate —— The maximum ingress rate of the specified packets. The packet traffic
To Next Page
Loading...
