TL-SL3428 JetStream L2 Managed Switch CLI Guide
19
TP-LINK(config)# interface ethernet 2
TP-LINK(config-if)# switchport allowed vlan add 2
switchport pvid
Description
The switchport pvid command is used to configure the PVID for the switch
ports.
Syntax
switchport pvid vlan-id
Parameter
vlan-id —— VLAN ID, ranging from 1 to 4094.
Command Mode
Interface Configuration Mode (interface ethernet / interface range ethernet )
Example
Specify the PVID of port 2 as 2:
TP-LINK(config)# interface ethernet 2
TP-LINK(config-if)# switchport pvid 2
switchport general egress-rule
Description
The switchport general egress-rule command is used to configure the
egress-rule of the general port.
Syntax
switchport general egress-rule vlan-id { untagged | tagged }
Parameter
vlan-id —— VLAN ID, ranging from 1 to 4094.
untagged | tagged ——egress-rule，untagged or tagged
Command Mode
Interface Configuration Mode ( interface ethernet / interface range ethernet )
Example
Specify the egress-rule of port 2 in vlan 3 as tagged:
To Next Page
Loading...
Need help?
General