TP-Link JetStream TL-SL3428 - Snmp-Rmon Alarm Enable; Show Snmp Global-Config

TL-SL3428 JetStream L2 Managed Switch CLI Guide
180
snmp-rmon alarm owner {index} [owner]
no snmp-rmon alarm owner {index}
Parameter
index —— The index number of the entry, ranging from 1 to 12. You can only
select one entry for each command.
owner —— The owner of the entry, ranging from 1 to 16 characters. By default,
it is monitor.
Command Mode
Global Configuration Mode
Example
Configure the owner of entry 1 as owner1:
TP-LINK(config)# snmp-rmon alarm owner 1 owner1
snmp-rmon alarm enable
Description
The snmp-rmon alarm enable command is used to enable SNMP-RMON
Alarm Management entry. To disable the corresponding entry, please use no
snmp-rmon alarm enable command.
Syntax
snmp-rmon alarm enable {index}
no snmp-rmon alarm enable {index}
Parameter
index —— The index number of the entry desired to enable, ranging from 1 to
12, in the format of 1-3,5.
Command Mode
Global Configuration Mode
Example
Enable the Alarm Management entries 1,2,3,4 and 8:
TP-LINK(config)# snmp-rmon alarm enable 1-4,8
show snmp global-config
Description