TP-Link JetStream TL-SL3428 - Acl Policy Policy-Add

TL-SL3428 JetStream L2 Managed Switch CLI Guide
138
{smask source-ip-mask}] [[dip destination-ip] {dmask destination-ip-mask}]
[tseg time-segment] [index idx]
Parameter
acl-id —— The desired Standard-IP ACL for configuration.
rule-id —— The rule ID.
op —— The operation for the switch to process packets which match the rules.
There are two options, discard and permit. Discard means discarding packets,
and permit means forwarding packets. By default, the option is permit.
source-ip —— The source IP address contained in the rule.
source-ip-mask —— The source IP address mask. It is required if you typed
the source IP address.
destination-ip —— The destination IP address contained in the rule.
destination-ip-mask —— The destination IP address mask. It is required if you
typed the destination IP address.
time-segment —— The time-range for the rule to take effect. By default, it is
not limited.
index —— Change the index number of the entry.
Command Mode
Global Configuration Mode
Example
Edit Rule 10 for the Standard-IP ACL whose ID is 120. In the rule, the source IP
address is 192.168.0.100, the source IP address mask is 255.255.255.0, the
time-range for the rule to take effect is tSeg1, and the packets match this rule
will be forwarded by the switch:
TP-LINK(config)# acl edit rule std-acl 120 10 op permit dip 192.168.0.100
dmask 255.255.255.0 tseg tSeg1
acl policy policy-add
Description
The acl policy policy-add command is used to add Policy. To delete the
corresponding Policy, please use no acl policy policy-add command. A Policy
is used to control the data packets matching the corresponding ACL rules by
configuring ACLs and actions together for effect. The operations here include
stream mirror, stream condition and redirect.