TP-Link JetStream TL-SL3428 - Port Rate-Limit; Port Rate-Limit Disable Ingress

TL-SL3428 JetStream L2 Managed Switch CLI Guide
114
exceeding the bandwidth will be discarded. The value of it can be 128k | 256k |
512k or 1m | 2m | 4m | 5m | 10m | 20m | 40m | 50m.
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Enable the Storm Control function for port5 and specify the rate as 128kbps:
TP-LINK(config)# interface ethernet 5
TP-LINK(config-if)# storm-control bc-status enable mc-status enable
ul-status enable rate 128k
port rate-limit
Description
The port rate-limit command is used to configure the Rate Limit for an Ethernet
port. To disable the Rate Limit, please use no port rate-limit command.
Syntax
port rate-limit [ ingress ingress-rate ] [egress egress-rate ]
no port rate-limit
Parameter
ingress-rate —— Specify the bandwidth for receiving packets.Range:1-102400
for the megaport, 1-1024000 for the gigaport.
egress-rate —— Specify the bandwidth for sending packets. Range:1-102400
for the megaport, 1-1024000 for the gigaport.
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Configure the ingress-rate as 5120Kbps and egress-rate as 1024Kbps for port5:
TP-LINK(config)# interface ethernet 5
TP-LINK(config-if)# port rate-limit ingress 5120 egress 1024
port rate-limit disable ingress
Description
The port rate-limit disable ingress command is used to disable the