TP-Link JetStream TL-SL3428 - Show Logging Buffer; Show Logging Flash

TL-SL3428 JetStream L2 Managed Switch CLI Guide
84
show logging buffer
Description
The show logging buffer level command is used to display the log information
in the log buffer according to the severity level.
Syntax
show logging buffer level [level]
Parameter
level ——Severity level. There are 8 severity levels marked with values 0-7. The
information will be displayed only when the log with the same or smaller severity
level value. Display all the log information in the log buffer by default.
Command Mode
Any Configuration Mode
Example
Display the log information from level 0 to level 5 in the log buffer:
TP-LINK(config)# show logging buffer level 5
show logging flash
Description
The show logging flash level command is used to display the log information
in the log file according to the severity level.
Syntax
show logging flash level [level]
Parameter
level ——Severity level. There are 8 severity levels marked with values 0-7. The
information will be displayed only when the log with the same or smaller severity
level value. Display all the log information in the log file by default.
Command Mode
Any Configuration Mode
Example