3.3.2 Standard Titration Parameters
This section is applicable directly to a Standard Titration procedure. The user is able to set the
Titration variables to their requirements…
1. Select the Titration menu (
→
→→
→
F4:Setup
→
→→
→
F6:Titr.).
2. Select F5:STD Parameters from the menu. The following screen is displayed…
For pH Titrations… For mV and Relative mV Titrations…
STD Parameters
Endpoint : 7.00 pH
STD Parameters
Endpoint : 0 mV
F2:Negative
Enter the desired Endpoint, from 0 to 14 pH,
and press .
Enter the desired Endpoint, from 0 to 1500
mV, and press .
Press to alternately select a Negative or
Positive value for the Endpoint
3. The direction of the titration process can now be selected…
For mV and Relative mV Titrations…
STD Parameters
Titration Direction
>F1:Increasing pH
F3:Decreasing pH
STD Parameters
Titration Direction
>F1:Increasing mV
F3:Decreasing mV
Press when using an alkaline titrant that
increases the pH of the sample.
Press when using an acidic titrant that
decreases the pH of the sample.
Press to quit and retain the current
setting.
Press when using a titrant that increases
the Millivolts of the sample.
Press when using a titrant that decreases
the Millivolts of the sample.
Press to quit and retain the current
setting.
4. The Titration Parameters are now set. A Standard Titration can now be performed.
To Next Page
Loading...
