138
7. Using a propane torch, heat the gear case to approxi-
mately 200° F (93° C). Carefully using the Pinion
Gear/Shaft Removal tool, remove the pinion gear.
PK252
8. Remove the snap ring securing the needle bearing to
the gear case; then, using a suitable bearing puller,
remove the bearing.
PK253
PK254
9. Place the pinion gear assembly into a bearing puller;
then using a press, separate the bearing from the pin-
ion. Account for the shim, as it is required to be re-
used upon assembly.
PK255
PK256
10. To replace the cover bearing, use a suitable seal
puller to remove the seal; then drive the bearing out
from the outside of the cover.
11. To replace the case side bearing, use a suitable seal
puller to remove the seal; then remove the snap ring
securing the case side bearing.
PK257
12. Using a bearing driver, remove the case side bearing
from the inside of the case.
CAUTION
Protective equipment should be worn, as severe injury
or burns could result.
To Next Page
Loading...
