24 RT-SVP011E-EN
TD7 Display
Setting Up a Temporary Override
You can set up a temporary override by using the buttons in the Temporary Override area. The
default duration for temporary overrides is 2 hours 0 minutes. The maximum duration for a
temporary override is 99 hours 59 minutes. If more time is needed, consider setting up a permanent
override.
1. Touch the Set to Expire button.
A check mark appears in the check box, the override icon becomes blue, and the Time
Remaining area ap
pears.
2. Touch either the hours (HH) or minutes (MM) button, then use the up and down arrows to
set
the override.
The HH and MM buttons, when pressed change by o
ne increment.
Press down on the buttons
to accelerate. A second touch of the (HH) or (MM) buttons will open the Analog keypad screen.
Touch the Apply or Save button to set the te
mporary override.
Override Summary
The TD7 has a built in override summary report. Touch the Override Summary button on the Points
screen.
The Override Summary screen contains all active overrid
es. Columns are sortable and
automatically default to Time Remaining.
The override icon (
) indicates that a point override is in effect indefinitely. The temporary
override icon (
) indicates that an override will expire after a specified duration.
To release all overrides in the list, touch the Release All O
verrides button (only points that are
controlled at the TD7 user’s priority level will be released). Touch anywhere in a point row to
navigate to the corresponding Point Override screen.
Figure 21. Override Summary screen
To Next Page
Loading...
