Figure 49. Symbio™ UI Points
RT-SVP011E-EN 71
Symbio™ UI
Deleting Points
Deleting points is convenient for removing unwanted data from the controller communication
interface. The point is not permanently deleted; rather the point is simply moved to Recycled
Points.
All point overrides, priority ar
ray owners, and status are reset to
factory settings.
To delete a point:
1. Click Points in
left navigation pane
.
2. Navigate to Analog, Binary, or Multistate points and select the point(s)
using check box left of
name.
3. Select Actions pull-down menu
, then Delete > Yes – Delete to confirm the action. No – Cancel
to cancel action.
Recycled Points
Points that have been deleted from the controller interface are moved to Recycled Points. In this
location the points can be restored to the controller interface and used once again to communicate
data via BACnet
®
, MODBUS
®
or LonTalk
®
.
To view recycled points and restore points:
1. Click Points in
left navigation pane
.
2. Click Recycled Points to
view all deleted points.
3. To resort a point, click the box left of the point name,
then click Restore.
Creating a Data Log
1. Click Points in left navigation pane.
2. Navigate to Analog, Binary, or Multistate points and select the point(s)
using check box left of
name.
3. Select Acti
ons pull-down menu, then Log D
ata and complete the settings.
4. Select Data Log Type and edit settings for the type.
a. Data collec
tion start on a schedule, click Next to setup schedule information.
To Next Page
Loading...
