Programming Codes iTherm
®
280 Programmer’s Guide
28-04430 Rev K Page 99
Character Attributes
[ESC] c Select color
ASCII [ESC] c <n>
Hexadecimal 1BH 63H <n>
Decimal <27> <99> <n>
IPCL &%CL <m
1
>
EPOS none
Description The [ESC] c <n> command selects the print color, and should match the
color of the pen installed.
Where <n> 0 = Black
1 = Red
2 = Green
3 = Blue
[SO] Begin one-line double-wide print
ASCII [SO]
Hexadecimal 0EH
Decimal <14>
IPCL &%MW
EPOS none
Description The [SO] command causes subsequent characters to be printed at twice
the currently selected character width. For example, ten cpi becomes five
cpi, 17 cpi becomes 8.5 cpi, etc. The [SO] command remains in effect
until: A valid line terminator is received ([CR], [LF], or [ESC] J <n> (fine
line feed)); The command is canceled; or the maximum number of
characters per line is reached and the printer performs an auto-print.
[DC4] Cancel one-line double-wide print
ASCII [DC4]
Hexadecimal 14H
Decimal <20>
IPCL &%MN
EPOS none
Description The [DC4] command cancels one-line double-wide mode set by the [SO]
command and allows single- and double-wide characters to be printed on
the same line.
To Next Page
Loading...
