TransAct Ithaca 280 - Character Font

Configuring Your ITherm
®
280 Printer iTherm
®
280 Programmer’s Guide
Page 52 Rev K
Using Configuration Mode
The Feed button is used to select and change configuration setting. By pressing and
releasing the Feed button, the parameter to be changed can be selected. By pressing
and holding the Feed button, the value of the selected parameter will change.
The following chart lists some of the potential parameters and their options.
Parameter
Definition
Options
Default
Emulation Mode
Printers command set
Ithaca PcOS, Epson TM-
TXX, ESC/POS,
Microline, Ithaca M50
Ithaca PcOS
Model
Type of Epson Printer
TM-T85, TM-T88II, TM-
T88III, TM-T90
TM-T88II
Paper Colors
Black Dot Eo
This option allows the
Custom Black or Custom
Color paper Black
energy to be set.
10 to 40
24
Red Dot Eo
This option allows the
Custom Color paper
Color energy to be set.
10 to 40
12
Color
This option selects the
secondary paper color
Monochrome, Red,
Green, or Blue
None
Density Adjust
This is a fine adjustment
for the print density.
-50 to + 50
0
Baud Rate
Serial Communications
Bit rate
300, 600, 1200, 2400,
4800, 9600, 19200,
38400, 57600,115200
19200
Mode
Number of bits, parity
and stop bits.
7 bit or 8 bit
Even, Odd, No Parity
1 or 2 Stop Bits
8 Bit, No parity, 1 Stop
bit
Handshaking
Flow control options
Ready/Busy
Xon/Xoff
None
Ready/Busy
Receive Error
What happens when an
error is detected.
Prints ?
Ignores the data.
Prints ?
Windows PnP
Flag for Windows Plug
and Play active.
Enabled,
Disabled
Enabled.
DTR/RTS Signal
What RS232 signals are
used for flow control
DTR, RTS, or Both DTR
and RST
Both DTR and RTS
CTS/DSR Signal
How CTS and DSR used
None (Not used)
None (Not used)
Multidrop Mode
Flag for multidrop active
Off, A, B, or C Address
Off
Busy-to-ACK
Relationship of Busy to
ACK on the IEEE1284
interface.
ACK while Busy
ACK in Busy
ACK after Busy
ACK in Busy
Select/Deselect
Command used for
printer select and
deselect (Microline and
M50 only)
DC3/DC1
DC1/DC3
DC3/DC1
Code Page or
Language Set
What character set is
used for a default.
See appendix
0 or 437
Zero
Is the zero slashed, un-
slashed or defined by
the language set.
Slashed
Un-Slashed
Follow Language set
Defined by the language
set.
Font
Sets the size of the
default font
9x24, 10x24, 13x24, or
15x24
12 x 24
CPI
Sets the default
characters per inch
Value may be form 10 to
24 characters per inch
15