TransAct Ithaca 280 - Table 53 Peripheral Device Bit Definitions

Programming Codes iTherm
®
280 Programmer’s Guide
28-04430 Rev K Page 225
Function Clear buffer(s)
ASCII [DLE] [DC4] <8> d1…d7
Hexadecimal 10H 14H <8> d1…d7
Decimal <16> <20> <8> d1…d7
Range d1=1, d2=3, d3=20, d4=1, d5=6, d6=2, d7=8
Description The [DLE] [DC4] <8> command clears all data stored in the receive buffer and
the print buffer.
Transmits the following three bytes of data
Hex
Decimal
Amount of data
Header
37H
55
1 byte
Flag
25H
37
1 byte
NUL
00H
0
1 byte
Enters in standard mode
Function Select Peripheral Device Status
ASCII [ESC] = <n>
Hexadecimal 1BH 3DH <n>
Decimal <27> <61> <n>
Range 1  n  3
Description The [ESC] = <n> command selects the device to which the host computer sends
data, based on the value of <n> listed below.
Bit
Off/On
Hex
Decimal
Function
0
Off
00H
<0>
Printer disabled
On
01H
<1>
Printer enabled
1
Off
00H
<0>
Customer display disabled
On
02H
<2>
Customer display enabled
2-7
-
-
-
Undefined
Table 53 Peripheral Device Bit Definitions
Note: Epson Customer display is not supported by the iTherm
®
280
printer.