TransAct Ithaca 280 - Supported TM-T88 Commands

Programming Codes iTherm
®
280 Programmer’s Guide
28-04430 Rev K Page 181
Supported TM-T88 Commands
Print and Feed Commands
Command
Name
Page
LF
0AH
Print and line feed
190
CR
0DH
Print and carriage return
190
ESC d
1BH,64H
Print and feed <n> lines
190
ESC J
1BH,4AH
Print and feed paper <n> vertical units
191
Line Spacing Commands
Command
Name
Page
ESC 2
1BH,32H
Select default line spacing, 1/6 lpi
192
ESC 3
1BH,33H
Set line spacing
192
Character Commands
Command
Name
Page
ESC SP
1BH,20H
Set right-side character spacing
192
ESC !
1BH,21H
Select print mode(s)
198
ESC %
1BH,25H
Select/cancel user-defined character sets
192
ESC &
1BH,26H
Define user-defined characters
193
ESC -
1BH,2DH
Turn underline mode on/off
198
ESC ?
1BH,3FH
Cancel user-defined characters
193
ESC E
1BH,45H
Turn emphasized mode on/off
198
ESC G
1BH,47H
Turn double-strike mode on/off
199
ESC M
1BH,4DH
Select character font
193
ESC R
1BH,52H
Select an international character set
194
ESC V
1BH,56H
Turn on/off 90 rotation mode
199
ESC t
1BH,74H
Select character code table
197
ESC {
1BH,7BH
Turn upside-down printing mode on/off
199
GS !
1DH,21H
Select character size
200
GS B
1DH,42H
Turn white/black reverse printing mode on/off
197
Panel Button Commands
Command
Name
Page
ESC c 5
1BH,63H,
35H
Enable/disable panel buttons
201
Paper Sensor Commands
Command
Name
Page
ESC c 4
1BH,63H,
34H
Select paper sensor(s) to stop printing
202
ESC c 3
1BH,63H,
33H
Select paper sensor(s) to output paper out
signals
203