Programming Codes iTherm
®
280 Programmer’s Guide
Page 102 Rev K
[ESC] - Begin underline
ASCII [ESC] - <n>
Hexadecimal 1BH 2DH 01H
Decimal <27> <45> <n>
IPCL &%MU (Begin)
IPCL &%CU (End)
EPOS [ESC] ! <n>
Description The [ESC] - <1> command begins underline print mode. All subsequent
text, leading spaces, and trailing spaces are underlined. [ESC] - <0>
ends the mode.
Note: In EPOS mode, [ESC] ! <n> performs a similar function; however,
near letter quality (NLQ) is not available.
[ESC] G Begin enhanced print
ASCII [ESC] G
Hexadecimal 1BH 47H
Decimal <27> <71>
IPCL &%ME
EPOS [ESC] G <1>
Description All subsequent text is printed in enhanced print mode (two passes with a
vertical offset). Enhanced printing provides a deeper resolution of each
character and may enhance multiple part forms printing.
[ESC] H End enhanced print mode
ASCII [ESC] H
Hexadecimal 1BH 48H
Decimal <27> <72>
IPCL &%CE
EPOS [ESC] G <0>
Description The [ESC] H command cancels enhanced print mode and returns to the
currently selected font.
[ESC] E Begin emphasized print mode
ASCII [ESC] E
Hexadecimal 1BH 45H
Decimal <27> <69>
IPCL &%MM
EPOS [ESC] E <1>
Description The [ESC] E command begins emphasized print mode (one pass with
horizontal offset). Emphasized print is bolder than normal print.
To Next Page
Loading...
