Programming Codes iTherm
®
280 Programmer’s Guide
28-04430 Rev K Page 109
[ESC] r <11> Begin 270 rotated print with two pass font
Not available in page mode
ASCII [ESC] r <11>
Hexadecimal 1BH 72H 0BH
Decimal <27> <114> <11>
IPCL &%RX11
EPOS none
[ESC] r <15> Begin 270 rotated print with two pass font and line formatting
Not available in page mode
ASCII [ESC] r <15>
Hexadecimal 1BH 72H 0FH
Decimal <27> <114> <15>
IPCL &%RX15
EPOS [ESC] T <1>
[ESC] r <0> End rotated print
ASCII [ESC] r <0>
Hexadecimal 1BH 72H 00H
Decimal <27> <114> <0>
IPCL &%R0
EPOS [ESC] { <0>
Description The [ESC] r <0> command prints the contents of the rotated print buffer
(when in 90 or 270 rotated mode) and returns to normal print
orientation. In 180 rotated mode, the printer returns to normal mode.
Characters in the print buffer that have not been printed are not printed.
To Next Page
Loading...
