TransAct Ithaca 280 - RS-232 Serial Interface; USB Interface

Specifications and Requirements iTherm
®
280 Programmer’s Guide
Page 12 Rev K
 CPI selections from 8 to 30 CPI
1
 Paper Out sensor
 Multiple printer emulations: Ithaca M80/M80+, Ithaca M50/M151 Micro-line,
Epson Extended, Epson TM-T88II/III, TM-T90, U200, U300, Axiohm
A793/4/5, Citizen and Star
 Maximum 8K buffer (adjustable)
 2 Megabytes Flash Memory
 2 Megabytes RAM
 APA and Epson graphics
 Bar Codes: Code 39, Code 93, Code 128, Interleaved 2 of 5, UPC-A, UPC-
E, EAN-8, EAN-13, EAN-14, PDF417 stacked symbology and Codabar
 65 Language sets (including Euro symbol)
 Metal receipt tear off
 8 dots/mm. thermal print head resolution
 ON/OFF button located on front of printer
 Cable routing strain relief
 Power/Error/Paper LEDs
 Paper feed button
 Cover open button
 Settable cash drawer configurations (Ithaca, Epson, or Star)
 Spill proof design- vertical main PCB mounting
 58 mm. or 80 mm. paper width – factory-settable
 4.0 inch (101 mm.) Paper roll diameter
 Portrait/landscape printing under Windows
 Page mode printing
 Cover Open sensor
 Electronic journal capability
 Internal counters for hours on, cuts, print lines and errors
 100 km print head life
 60 million print line printer MCBF (excluding knife)
 Strong break-away paper cover
 1,000,000 cuts cutter life (partial cut)
 Buzzer
 2 color printing (4 inches per second print speed)
1
Character spacing is adjustable from 1 to 30 CPI. Typical values will be between 8 and 20 CPI
depending on the font selected. Values of 13.3, 14.86, or 17.3 are typical for each resident font.
2
CPI‘s greater than 16 will not be supported in NLQ fonts