ITherm
®
280 Color Graphics iTherm
®
280 Programmer’s Guide
28-04430 Rev K Page 253
&%UQ& Report on user store
IPCL &%UQ&
Description The &%UQ& command prints a status report. The intention of the
command is to aid in universal graphic development.
&%UT<n> Redefine User Store Termination Character
IPCL &%UT<n>
Description This command allows the terminator used to signal the end of the name
field in User Store commands to be modified. The value of <n> is used
for the terminator. The value of n may be from 0 to 255.
Example If &%UT% were sent to the printer the User Store command to run
universal graphic "Demo" would be &%URDemo%.
&%CL Set Print Color
IPCL &%CL <n>
Description This command allows various colors to be selected on printer emulations
that do not support color text.
Where n: 0 Print with the Left cartridge (Typically Black)
1, 2, 3 Print with the Right cartridge (Typically Red, Blue, or Green)
&%UA Cycle Auto-Cutter
IPCL &%UA <m
1
> <m
2
> <m
3
>
Description This command feeds m/96 inches of paper and cycles the auto cutter.
Where m: m = m
1
* 100 + m
2
*10 + m
3
To Next Page
Loading...
