TransAct Ithaca 280 - Recovery from Mechanical Errors; EEPROM READ ERROR; EEPROM WRITE ERROR; SOFTWARE ERROR VECTOR

Communications iTherm
®
280 Programmer’s Guide
Page 280 Rev K
where X is a model definition. X will be 3 if the printer is in the native iTherm
®
280
emulation. 5 indicates that the printer is in some other emulation. Y and Z are bit fields
that designate the options attached to the printer.
Bit
Y
Z
Bit 0
Color Support active
0
Bit 1
Undefined
Knife module attached
Bit 2
Undefined
0
Bit 3
0
0
Bits 4-5
1
1
Bits 6-7
0
0