TransCore MPRX Series - Page 129

Table 38 MPRX Commands Listed Alphabetically
Command Name Number Reader Message
Set check tag character on check
tag pin 0
8142X
#Done
Set check tag character on check
tag pin 1
8143X
#Done
Set date 21
#Done
Set ECP timeout 612NN
#Done
Set ECP timeout = 12.7 sec
(default)
612FE
#Done
Set reader ID number 60NN
#Done
Set RF attenuation 644NN
#Done
Set RF timeout 693N
#Done
Set RF timeout = infinite (default) 693F
#Done
Set SeGo protocol operating range
(distance)
645NN #Done
Set serial number S...S = ASCII
string (max 6 characters) (default)
695S...S #Done
Set time 20 #Done
Set uniqueness time-out to 15
seconds
442 #Done
Set uniqueness time-out to 2
minutes (default)
441 #Done
Set uniqueness time-out to 30
seconds
443 #Done
Set user-programmable group select
equals (GSE) filter
697 #Done
Store hardware configuration
string S...S (max 20 characters)
(default)
696S...S #Done
Switch on RF port 0, fire o check
tag address 0 on check tag pin 0
8110 #Done
Switch on RF port 1, fire o check tag
address 1 on check tag pin 0
8111 #Done
Switch on RF port 2, fire o check
tag address 0 on check tag pin 1
8112 #Done
Switch on RF port 3, fire o check
tag address 1 on check tag pin 1
8113 #Done
Appendix D Command Quick Reference
TransCore Proprietary
D–129