TransCore MPRX Series - Page 128

Table 38 MPRX Commands Listed Alphabetically
Command Name Number Reader Message
Select 3 valid ID codes 4202
#Done
Select 4 valid ID codes 4203
#Done
Select basic protocol (default) 610
#Done
Select ECP protocol 611
#Done
Select even parity 1021
#Done
Select four ID separation 4103
#Done
Select odd parity 1022
#Done
Select one ID separation (default) 4100
#Done
Select RF operating frequency 642NN
#Done
Select RF operating frequency from
860 to 930 in 250 kHz steps
647XXX
#Done
Select RF-by-input control (default) 641
#Done
Select three ID separation 4102
#Done
Select two ID separation 4101
#Done
Set ATA operating range (distance) 643NN
#Done
Set baud rate = 1200 baud 1002
#Done
Set baud rate = 19.2 K baud 1006
#Done
Set baud rate = 2400 baud 1003
#Done
Set baud rate = 38.4 K baud 1007
#Done
Set baud rate = 4800 baud 1004
#Done
Set baud rate = 9600 baud
(default)
1005
#Done
Set check tag address to 0 on check
tag pin 0
8150
#Done
Set check tag address to 0 on check
tag pin 1
8152
#Done
Set check tag address to 1 on check
tag pin 0
8151
#Done
Set check tag address to 1 on check
tag pin 1
8153
#Done
MPRX User Guide
TransCore Proprietary
D–128