TransCore MPRX Series - Page 73

x=1 antenna multiplexing between RF ports 0 and 1 when sense 0 active
x=2 antenna multiplexing between RF ports 0 and 1 when sense 0 active and RF port 2
when sense 1 active
x=3 antenna multiplexing between RF ports 0 and 1 when sense 0 active and RF ports 2
and 3 when sense 1 active
MPRX = MPRX mode selected
560 Request Sensor Status Change
#560 displays the sensor status change reporting. Not applicable to the MPRX
Reader response: SSTC E<0 to 1> M<0 to 3>
where
E0 Input status change reports disabled (factory default)
E1 Input status change reports enabled
M0 Reporting disabled (factory default)
M1 Changes on input 0 reported
M2 Changes on input 1 reported
M3 Changes on either input reported
For example, if factory default settings are assigned, the reader message is
SSTC E0 M0
which means that input status change reports are disabled on both input 0 and input 1.
570 Display Operating Mode Status
#570 displays the currently selected tag read mode.
Reader response: ATA:<E, D> eGo:<I, F, D> SeGo:<I, F, D> IAG:<E, D> Sort:<E, D> TMM0
where
I ID (64 bits)
E Enabled
F Full transaction (eATA)
D Disabled
TMM0 Fixed
577 Report Buered Handshakes
#577 reports the buered handshakes. When in MPRX mode and/or if antenna multiplexing
is enabled, the response is
Reader response: HDSH C0 <ww> C1 <xx> C2 <yy> C3 <zz>
where
ww count from port 0
xx count from port 1
Chapter 5 Commands
TransCore Proprietary
5–73