851 MUX Between RF Ports 0 and 1
#851 multiplexes between RF ports 0 and 1.
Reader response: #Done
852 MUX Between RF Ports 0, 1, and 2
#852 multiplexes between RF ports 0, 1, and 2.
Reader response: #Done
853 MUX Between RF Ports 0, 1, 2, and 3
#853 multiplexes between RF ports 0, 1, 2, and 3.
Reader response: #Done
891 MUX Test Mode RF Port 1 Only
#891 turns on RF port 1 only for antenna mux testing.
Reader response: #Done
Note: Refer to “MUX Test Modes” on page 5–85 for test operation.
892 MUX Test Mode RF Port 2 Only
#892 turns on RF port 2 only for antenna mux testing.
Reader response: #Done
Note: Refer to “MUX Test Modes” on page 5–85 for test operation.
893 MUX Test Mode RF Port 3 Only
#893 turns on RF port 3 only for antenna mux testing.
Reader response: #Done
Note: Refer to “MUX Test Modes” on page 5–85 for test operation.
Check Tag Operation
To enable check tag 0, issue the following commands:
#8110 turn on RF port 0, send the command on Ctag pin 0, to fire o Ctag address 0.
#8111 turn on RF port 1, send the command on Ctag pin 0, to fire o Ctag address 1.
#8142X send the command on Ctag pin 0 to set the Ctag character.
#8150 send the command on Ctag pin 0 to set the Ctag address to 0.
#8151 send the command on Ctag pin 0 to set the Ctag address to 1.
To enable check tag 1, issue the following commands:
#8112 turn on RF port 2, send the command on Ctag pin 1, to fire o Ctag address 0.
#8113 turn on RF port 3, send the command on Ctag pin 1, to fire o Ctag address 1.
#8143X send the command on Ctag pin 1 to set the Ctag character.
MPRX User Guide
TransCore Proprietary
5–84
To Next Page
Loading...
