8151 Set Check Tag Address to 1 on Check Tag Pin 0
#8151 sets the check tag address to 1 on check tag pin 0.
8152 Set Check Tag Address to 0 on Check Tag Pin 1
#8152 sets the check tag address to 0 on check tag pin 1.
8153 Set Check Tag Address to 1 on Check Tag Pin 1
#8153 sets the check tag address to 1 on check tag pin 1.
830 Disable Automatic Periodic RF Status Report (Factory Default)
#830 is a default set in the factory to disable the automatic periodic RF status report.
Reader response: #Done
831 Enable Automatic Periodic RF Status Report
#831 enables the automatic periodic RF status report. This function sends out a periodic RF
status report if no other message (a tag read) is sent from the reader for a period of
time. This message is the same message that would be sent in response to the #527
Display RF Status command. Enabling this function is helpful in some sites where there
may not be much tag activity, and the user wants an automatic way to ensure the
communication channel with the reader is still intact. With this function enabled, the
host system will get a message from the reader at least every three minutes.
Reader response: #Done
836 Disable MPRX Mode
#836 disables the MPRX mode.
Reader response: #Done
837 Enable MPRX Mode
#837 enables the MPRX mode.
Reader response: #Done
842 Disable AI1200 Emulation Mode
#842 disables the AI1200 Emulation mode.
Reader response: #Done
843 Enables the AI1200 Emulation Mode
#843 enables the AI1200 Emulation mode.
Reader response: #Done
850 MUX RF Port 0 (Factory Default)
#850 enables RF port 0, which disables antenna multiplexing.
Reader response: #Done
Chapter 5 Commands
TransCore Proprietary
5–83
To Next Page
Loading...
