TransCore MPRX Series - Page 99

Chapter 6 Configuration
TransCore Proprietary
6–99
To test the read zone
1. Ensure that the MPRX is in data mode.
2. With the MPRX operating, place one tag behind your back while you hold another tag in the new
read zone. If a valid read, the data from the tag held in the read zone displays on the host device
screen.
3. Switch tags, placing the other tag behind your back and holding the first tag in the read zone. If a
valid read, the data from this tag held in the read zone displays on the host device screen.
4. If both tags are read, you have successfully adjusted the read range. If one or both tags did not
read, follow the suggestions in “Verifying Tag Read Capability” on page 6–90.