transnorm TS 1300 - Page 65

Maintenance and repair
Replacing the conveyor belt
65
 Disassemble the
upper belt edge
holder parts - lower
run
Complete the following steps:
1. Turn the locking lever to "Open".
2. Remove the upper belt edge holder parts (1).
 The upper belt edge holder parts have been disassembled - lower run.
 Disassemble the
cross beams, only
for BN > 1200 mm
Complete the following steps:
1. Release the joining elements (1) of the cross beams (2).
2. Lift the bed and remove it to the side.
 The cross beams have been disassembled, only for BN > 1200 mm.
1
1
2