Maintenance and repair
Replacing the flange bearings
79
Assemble the flange
bearings
Complete the following steps:
Assembly must be carried out in the reverse order.
Please pay attention to the direction of the counter support (1) when
inserting the joining elements on the flange bearing.
The flange bearings have been assembled.
Tighten/adjust the
belt
Complete the following steps:
Proceed as described in "Tightening/adjusting the belt".
The belt has been tightened/adjusted.
Assemble the gear
motor
Complete the following steps:
Only applicable for shaft-mounted drive: Proceed as described in
"Replacing the gear motor".
The gear motor has been fitted.
The flange bearings have been replaced.
To Next Page
Loading...
