Transonic TS420 - Guarantee, Service and Warranty

36 AU-OPR-400Ser-EN,
Rev D
Appendix C: Symbols & Signs
The following table contains a list of the possible symbols with accompanying denitions. Not all symbols
are applicable to all products.
FAILURE TO COMPLY WITH ALL WARNINGS BOTH WRITTEN AND SYMBOLIC COULD RESULT IN PATIENT INJURY OR
EQUIPMENT DAMAGE, AND VOID ANY AND ALL WARRANTIES.
LEGEND SYMBOL DEFINITION TRANSONIC NOTATION
Yi
Attention, Consult
Accompanying
Documents
The specic directions in this manual and in the package inserts included
with each device must be observed. Periodic testing of devices must be
performed to assure the validity of ow measurements.
Dangerous Voltage
The device must not be modied or serviced except by qualied
Transonic
®
repair personnel.
AP
Not Category AP
Equipment
Danger-Explosion risk if used with ammable anaesthetics.
Equipotentiality
This ground pin is connected to the metal cabinet of the monitor. It
provides the User with a means to equalize the electrical potential when
connecting the device to other equipment.
Waste Electrical and
Electronic Equipment
This device contains material that requires special waste handling
procedures for disposal. Contact Transonic
®
Customer Service to arrange
for disposal.
C
CE Conformity Mark
This device conforms to the requirements of applicable EU directives.
See the Declaration of Conformity accompanying this device for specic
directives.
ETL Testing Mark Electrical Safety Compliance Certication
P
Authorized
Representative
Transonic Systems Europe is an authorized representative in the European
Community
TUV Testing Mark Electrical Safety Compliance Certication
RoHS
LEAD - FREE
RoHS Compliant
This device was manufactured in accordance with RoHS requirements for
applicable hazardous material content.
p
Keep Dry
Do not expose the device to excessive liquids. Dry immediately if exposed
to any liquids.
:
l
:
Temperature Limits
Do not expose the device to temperatures above or below those listed.
Different temperature limits may apply to transportation, storage and use
of the device.
H
Use By Date Do not use this device after the end of the day, month or year shown.
N
Manufacture Date This device was manufactured on the date listed.
M
Manufacture Location This device was manufactured by the company listed; at the location listed.
g
Batch Code The number listed is the lot number/batch code for the device.
h
Reference Number The number listed is the catalog, reorder or reference # for the device.
f
Serial Number The number listed is the serial number for the device.
90%
0%
Humidity
Do not expose the device to humidities above or below those listed.
Different humidity limits may apply to transportation, storage and use of
the device.