Installation (for qualified installers only) 15
© Travis Industries 3/13/18 - 1474 42 & 54PB GSB2 Aust.
Standard vs. Extended Position
There are two positions that the standoff/heat shield assembly can be installed. The standoffs are
shipped in the standard (forward) position.
• If the unit is installed in the standard position no modification is needed.
• If the unit is being installed in the extended position, the standoff/heat shield assembly must
be repositioned back ½” (see illustration below).
NOTE: see pages 14 & 38.for additional details about standard vs. extended installations.
To Next Page