TRENDnet 14dBi User Manual

User Manual
TEW-455APBO High Power Wireless Outdoor PoE Access Point
62
Chapter 5. CPE Mode Configuration
When CPE mode is chosen, the system can be configured as a Customer Premises Equipment (CPE). This
section provides detailed explanation for users to configure in the CPE mode with help of illustrations. In the
CPE mode, functions listed in the table below are also available from the Web-based GUI interface.
OPTION
System
Wireless
Advance
Utilities
Status
Functions
Operating Mode
General Setup
DMZ
Management
System Overview
WAN
Wireless Profile
IP Filter Setup
Profiles Settings
DHCP Clients
LAN
Site Survey
MAC Filter Setup
Firmware
Upgrade
Extra Info
DDNS Setup
Virtual Server
Network Utility
Event Log
Time Server
Reboot
SNMP
UPNP
Table 5-1: CPE Mode Functions
5.1 External Network Connection
5.1.1 Network Requirement
It can be used as an Outdoor Customer Premises Equipment (CPE) to receive wireless signal over last mile
application, helping WISPs deliver wireless broadband Internet service to residents and business customers. In
the CPE mode, TEW-455APBO is a gateway enabled with NAT and DHCP Server functions. The wired clients
connected to TEW-455APBO are in different subnet from those connected to Main Base Station, and, in CPE
mode, it does not accept wireless association from wireless clients.
Figure 5-1 CPE mode configuration

TRENDnet 14dBi Specifications

General

Brand	TRENDnet
Model	14dBi
Category	Wireless Access Point
Language	English