WDS
WDS Link
Wireless (2.4GHz or 5GHz) > WDS Link Settings
This section outlines the available features to configure for both wireless 2.4Ghz and
5GHz when WDS mode is selected.
1. Log into your management page (see “Access the management page” on page 13).
2. Click on System, and select Operation Mode.
3. Enable WDS Access Point, under the wireless band (2.4GHz or 5GHz) you would like
to connect this access point to. Please make sure that the selected band is available
on your network.
4. Click on the wireless band you would like to configure and click WDS Link Settings.
5. Configure the below settings and click Save to save settings.
• Site Survey: Click this option to scan for available WDS networks
• Remote AP MAC: Enter the MAC address of the remote access point you want to
establish WDS connection.
To Next Page
Loading...
Need help?
General
