• Security Mode: Select from the pull-down menu the wireless security that is used
on the wireless network you would like to connect to.
6. Click on Apply button to apply the settings and then click on the Save button located
on the top right section to save the settings.
Repeater
Basic
Wireless (2.4GHz or 5GHz) > Wireless Network
This section outlines the available features to configure for both wireless 2.4GHz and
5GHz when Repeater mode is selected.
1. Log into your management page (see “Access the management page” on page 13).
2. Click on System, and select Operation Mode.
3. Enable Repeater, under the wireless band (2.4GHz or 5GHz) you would like to connect
this access point to, then press Save. Please make sure that the selected band is
available on your network.
4. Click on the wireless band (Wireless 2.4GHz / Wireless 5GHz) you would like to
configure and click Wireless Network.