5. Click on Apply button to apply the settings and then click on the Save button located
on the top right section to save the settings.
Advanced wireless settings
Wireless (2.4GHz or 5GHz) > Advanced Wireless
1. Log into your management page (see “Access the management page” on page 13).
2. Click on the wireless band you would like to configure and click Wireless Advanced
Settings.
3. Review the settings and click Save to save settings.
Advanced Wireless
• Data Rate: Select the operating wireless data rate.
• Transmit Power: The wireless transmit power can be modified to lower the
antenna strength setting from 25 dBm to 11 dBm, if necessary. Lowering the
wireless transmit power may help to better stabilize the wireless connectivity and
reduce the effects of wireless interference in areas where there are several 2.4GHz
wireless devices. (Default: 18 dBm)
• RTS/CTS Threshold: The Request To Send (RTS) function is part of the networking
protocol. A wireless device that needs to send data will send a RTS before sending
the data in question. The destination wireless device will send a response called
Clear to Send (CTS). The RTS Threshold defines the smallest data packet size
allowed to initiate the RTS/CTS function.
Default Value: 2347 (range: 256-2346)
• Beacon Period: A beacon is a management frame used in wireless networks that
transmitted periodically to announce the presence and provide information about
the access point’s wireless network. The interval is the amount time between each
beacon transmission.
• DTIM: DTIM is a countdown informing clients of the next window for listening to
broadcast and multicast messages. When the access point has buffered broadcast
or multicast messages for associated clients, it sends the next DTIM with a DTIM
To Next Page
Loading...
Need help?
General
