Static IPv6
Static IPv6 are static IP addresses that are usually provided by your Internet Service
Provider (ISP).
1. Review the Static IPv6 settings below.
LAN IPv6 Address: Enter the IPv6 IP address provided to you by your Internet Service
Provider (ISP)
Subnet Prefix Length: Enter the prefix length of your subnet mask
Default Gateway: Enter the default gateway of your Internet Service Provider (ISP)
Primary DNS Server / Secondary DNS Server: Enter the Primary and Secondary DNS
server provided to you by your local Internet Service Provider (ISP)
Auto Configuration (SLAAC/DHCPv6)
1. Review the IPv6 DNS Settings below.
2. Select either Obtain IPv6 DNS server address automatically or Use the following IPv6
DNS Servers.
• Obtain IPv6 DNS server address automatically: Selecting this option will allow
the access point to automatically search for the DNS server address that is
provided by your Internet Service Provider (ISP)
• Use the following IPv6 DNS Servers: Selecting this option enables you to
manually input the Primary and Secondary DNS Servers
Change your IP address
System > IP Settings
In most cases, you do not need to change the IP address settings. Typically, the IP
address settings only needs to be changed, if you plan to use another access point in
your network with the same IP address settings, if you are connecting your access point
to an existing network that is already using the IP address settings your access point is
using.
Note: If you are not encountering any issues or are not faced with one of the cases
described above or similar, it is recommended to keep your router IP address settings as
default.
Default Access Point IP Address: 192.168.10.100 / 255.255.255.0
1. Log into your management page (see “Access the management page” on page 13).
2. Click on the System tab and click IP Settings.
3. Review the settings and click Apply to save changes.
To Next Page
Loading...
Need help?
General
