Trillium HD25 - Skylink Keyboard Shortcuts; Command Line Switches

Trillium User Guide Trillium Engineering Page 34
2.12 SkyLink Keyboard Shortcuts
Following keyboard shortcuts can be used with the Skylink application:
• + (Plus)
- Zoom in.
• - (Minus)
- Zoom out.
• Space (During Replay)
- Pause/resume replay.
• Space
- Sets the experimental geo-velocity matching mode's initial speed to match the current
ground speed. Joystick inputs are treated as impulses to this speed. Hitting space
again or switching to non-geo mode will stop geo-velocity mode.
• Ctrl-+ (Plus)
- Toggle crosshair on/off.
• Ctrl-C
- Copy image center LLA position to clipboard. Format is Latitude [tab] Longitude [tab]
Altitude HAE Meters.
• Ctrl-E
- Toggle local E-Stab on/off
• Ctrl-O
- Open a replay file.
• Ctrl-S
- Save a geotiff snapshot to the recording directory's "SnapShots" folder and add to
map. Same as clicking the SnapShot button.
• Ctrl-Space
- Add a GeoPoint at the image center LLA.
• Ctrl-Left Click on Video
- Offset position mode.
• Ctrl-Right Click on Video
- Add GeoPoint at click location.
2.13 Command Line Switches
To run command line switches, start a command line window in the SkyLink directory by
navigating to the directory in File Explorer, clicking on the location bar and typing CMD. To start
SkyLink or OrionUI with a command line switch, append the executable with a space and the switch
such as:
Skylink.exe --hilsim --nokill
Note the double dash.