EasyManuals Logo

Troxler 4140 User Manual

Troxler 4140
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #66 background imageLoading...
Page #66 background image
3-22
Remove the interface plate from the ram.
Lower the mounting plate.
Place the interface plate into the 150-mm loading head.
Install the mounting plate on the 150-mm loading head with the
eight screws removed earlier.
Set this 150-mm assembly aside.
The 100-mm loading head kit contains two thrust washers.
Install the large thrust washer, with the grey side up, into the
100-mm loading head. The pin in the loading head should
engage the hole in the thrust washer.
Use Magnalube-G to generously grease the grey surface of the
larger thrust washer. Be careful not to disengage the pin from
the thrust washer.
Set the greased 100-mm assembly aside.
Install the small thrust washer (supplied with the 100-mm kit),
with the grey side up, into the shallow recess of the interface
plate. The pin in the interface plate should engage the hole in
the thrust washer.
Use Magnalube-G to generously grease the grey surface of the
small thrust washer. Be careful not to disengage the pin from
the thrust washer.
Install the mounting plate over the interface plate. The mounting
plate should contact the greased surface.
Install the adapter (supplied with the 100-mm kit) onto the
interface plate, with the three holes on each part aligned.
Install this assembly onto the ram. Secure it with the three long
screws and the washers (supplied with the 100-mm kit). Tighten
the screws with a 3/16" Allen wrench.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Troxler 4140 and is the answer not in the manual?

Troxler 4140 Specifications

General IconGeneral
BrandTroxler
Model4140
CategoryLaboratory Equipment
LanguageEnglish

Related product manuals