3-18
AIRFLOW LIFT
NOTE
Airflow is very important for fast and complete burns.
Perform the procedure in this section before the first
burn.
NOTE
The unit was configured at the factory and requires
very little setup before the first burn.
Air enters the chamber through the hole in the bottom of the
furnace where the loadcell (scale) supports are positioned. This
incoming air creates lift on the stainless-steel hearth plate. (The
ideal range is between -2.5 and -3.5 grams.)
Figure 12: ICO Airflow
To Next Page
Loading...
Need help?
General
