5-16
AUTO-TIMER
The Auto-Timer function can be used to automatically power the
heating elements on and off at specified times and on specified
days.
NOTE
When the Auto-Timer powers down the heating
element, the control electronics and exhaust fan
remain powered.
NOTE
In the Auto-Timer mode, the oven will not turn off at
the programmed time if a burn cycle is in progress.
After the Auto-Timer has been enabled, the operator can disable
or suspend it as desired.
If the Auto-Timer is disabled, it will not turn the oven on or off.
To re-enable the Auto-Timer, the operator must re-enter all of
the Auto-Timer parameters (start and stop dates and times, and
so on).
If the Auto-Timer is suspended, the oven retains all of the Auto-
Timer parameters. The Auto-Timer can then be re-enabled
without requiring the operator to re-enter this information.
The following sections describe how to enable, disable, and
suspend the Auto-Timer.
ENABLING THE AUTO-TIMER
To enable the Auto-Timer, press 〈2〉 at the MAIN MENU shown
on page
5-2. If the Auto-Timer is not already enabled, the oven
requests the start date for the Auto-Timer as shown below. The
start date is the date on which the Auto-Timer is to begin
controlling power to the heating element.
To Next Page
Loading...
Need help?
General
