Chapter 3
INTERVAL key momentarily to view the current logging interval. Press and
hold the LOGGING INTERVAL key to sequence through the available
choices and release the key when the desired interval is on the display (LOG
1 mode only).
The logging interval is both a frequency and an averaging period. For
example, when the logging interval is set to 30-minutes, readings will be
recorded at 30-minute intervals. Each reading will be the average value
measured over a 30-minute interval.
As shipped from the factory, the available logging intervals for LOG 1 mode
are 1 second, 1 minute, 5 minutes, 15 minutes, and 30 minutes. Use the
T
RAKPRO Data Analysis Software to alter these values.
Programming the Logging Intervals using T
RAKPRO Software
To program the list of logging intervals available for LOG 1 mode:
1. Make sure the D
USTTRAK monitor is connected to the computer and
turned on.
2.
Select Parameters, then Logging Intervals from the Instrument
Setup menu. T
RAKPRO software retrieves the current logging intervals
from the D
USTTRAK monitor and displays them in the following dialog:
3.
Enter a value for each of the five available logging intervals (the range
is from 1 second to 59 minutes and 59 seconds).
4.
Select Send.
The D
USTTRAK monitor is reprogrammed to offer the logging intervals you
have specified.
To Next Page
Loading...
