Operation
Identifying an Instrument that may be Upgraded to Add
Analog/Alarm Functions
If your D
USTTRAK Aerosol Monitor was manufactured after August
1999 (serial number 21960 or later) and does not contain the
analog/alarm output connector, it may be upgraded at the factory to add
this feature. To verify this status, simply attach the instrument to the
T
RAKPRO software and attempt to program the Analog or Alarm
Setpoint functions. You should receive the following message:
This instrument may be returned to the factory, for a Cleaning,
Calibration and Upgrade (there is a charge for this service).
Identifying an Instrument That May Not Be Upgraded
If your D
USTTRAK Aerosol Monitor was manufactured prior to August
1999 (serial number 21959 or earlier), it is not hardware compatible
with these functions. It is not possible to upgrade these instruments to
add analog/alarm functions. To verify this status, simply attach the
instrument to the T
RAKPRO software and attempt to program the Analog
or Alarm Setpoint functions. You should receive the following message:
To Next Page
Loading...
