Operation
5. You can now disconnect the DUSTTRAK monitor and cable from the
computer.
Sample Protocol for LOG 2 and LOG 3 Modes
The following steps describe how to program a sample protocol for LOG 2
or LOG 3 mode.
The sample protocol for LOG 2 is set to take unattended aerosol readings for
one day, 11/02/2004. The logging sample begins at 8:00 a.m. and continues
for eight hours.
The sample protocol for LOG 3 is set up to take unattended aerosol readings
for two days, beginning on 11/02/2004. The logging sample begins at 8:00
a.m. and continues for eight hours. The instrument is off for 16 hours, and
then repeats the eight hours test on the following day.
The following graphic gives the appearance of the dialog box displayed in
the T
RAKPRO software, with these particular logging parameters.
To program this logging example, do the following:
1. Make sure the D
USTTRAK monitor is connected to the computer and
turned on.
05/09/2006 05/10/2006
To Next Page
Loading...
